Your cart is empty.
Your cart is empty.
SAFETY WARNING:
To extend anode rod life, drain water from the tank whenever RV is not being used.
Avoid any extended time of non-use with water in tank.
The suburban water anode heater rod doubles as a drain plug.
Set includes: 2 anode rods, 1 PTFE tape;
Dimensions: 9.25" Length ¾" NPT Threads;
Uses 1-1/16 inch socket (not included)
Compatible with Suburban and Mor-Flo models;
Material: Magnesium
QPQ RV Magnesium Anode Rod is used to replace the rusted bar in the water tank of the water heater, perfect replacement for Suburban and Mor-Flo models, and other 3⁄4" NPT threads water heaters. It can effectively prevent corrosion and rusting, prolong the life of your RV water tank.
QPQ RV Magnesium Anode Rod is made of Premium Magnesium AZ31B Alloy (97% Mg), which is an upgraded model of AZ63-T1 (90.7% Mg).A higher magnesium concentration can provide more adequate protection.
Anode Removal: Turn off the power to the water pump. Turn off the gas supply and the electrical power to the water heater. Be sure the water is cool before attempting to remove the anode rod. To remove, rotate counter-clockwise using a 1 1/16" socket wrench. It may take a lot of force to loosen, especially if it hasn't been removed in awhile. Stand clear when removing the rod, as water may splash. Drain water heater and flush sediments from the bottom of the tank.
New Anode Installation: Wrap threads clockwise with Teflon thread sealant tape or sealing compound that is approved for potable water. Insert new anode rod in drain opening and rotate clockwise to tighten.Turn on the water supply to refill the tank with water. Check around threads at the anode rod for leaks.If there is a leak tighten anode. Turn on gas supply and electrical power.
Ben Tanko
Reviewed in the United States on September 1, 2024
These are the exact size I needed. The included thread tape will take care of any minor thread damage. I wouldn’t hesitate to recommend these if they are the correct size.
Recommended Products
