Your cart is empty.
Your cart is empty.Use the 1-1/2 in. Carbide Tipped SDS Max Masonry Drill Bit with any SDS Max rotary hammer to quickly and effectively drill 1.5 in. diameter holes up to 20 in. deep. Comprised of hardened tungsten carbide cutting teeth and high speed forged steel body, this bit is designed for long-lasting performance. Compatible with all SDS Max Rotary Hammers.
Karl
Reviewed in the United States on September 30, 2024
Used this for drilling into rocks for placing t-posts on a hill; it worked very well but by the end the tip was completely worn down.
Steve-O
Reviewed in Canada on September 16, 2024
The media could not be loaded.
stefan
Reviewed in Canada on August 16, 2024
review scare me but i give a chance and it’s make 15. 12inches deep holes in rock ,im happy ,i have use a hilti 70 drill
Kevin
Reviewed in the United States on May 9, 2024
Drilled 20 holes. After the tenth hole it slowed down some but each hole took about 4 minutes start to finish using the full 2'.
Jean-Sébastien G.
Reviewed in Canada on September 1, 2023
Après avoir fait 5-6 trous!Le bout a cassé.
corey
Reviewed in Canada on August 4, 2023
i never hear what you going do for me yet never got refund
JC
Reviewed in the United States on March 3, 2023
Works great bought for driving T posts in the rock! The best price I could find and this is definitely a high quality thanks
Jimmy Gazallo
Reviewed in the United States on December 24, 2023
Great, bit did the job worked with it for hours and still good , over 30 holes in the rocks the trick is to use a smaller bit first to drill a pilot hole, then use that one, I started with a 1/2 inch and then 1 inch and then the 1-1/2
Jo Dennis
Reviewed in the United States on June 16, 2022
I had to drill through 18" of block faced with 4" of natural stone. Went through the stone fine but a little slower through the block. If I lost this drill, I would replace it with the same. Fair value.
Recommended Products
