Your cart is empty.
Your cart is empty.Specification: Suitable Models: for Tesla Model 3 Model Y Model S Model X Size: 6.8 inch x 0.6 inch Material: Made of ABS Package: 1 x Dual Motor Badge Easy to Install: Tear off the double-sided tape on the back of the product and stick it directly on the installation location Notice: 1. Please allow 1-3cm error due to manual measurement. pls make sure you do not mind before you bid. 2. Due to the difference between different monitors, the picture may not reflect the actual color of the item. Thank you! 3. Before sticking, please keep the sticking area clean and free of any moisture. Otherwise, it will affect the firmness! Installation Step: Step1: Clean the surface where you want to stick. Keep dry and clean. Step2: Determine the installation location and then make comparison of the product and installation location. Step3: 3M Adhesive Tape. No cutting or drilling required. Step4: Align position and then paste. The paste effect depends on paste conditions and correct installation. Step5: Please do press hard especially on the edges at least 2 mins after installing. Step6: Please don't touch water and Keep dry after been install at least 48 hours. Or it will easy to fall off. Installation Tips(Important): Adhesiveness is weaker when the temperature below 10℃(50℉), using hair drier to heat the thermal double-sided adhesive will be better.After the installation finished,the adhesive tape does work in low temperature.