Your cart is empty.
Your cart is empty.Product Description
Feature:
- Gas Springs printed a waterproof material on the surface, dustproof, easy to clean.
- Easy to install with simple tools in just a few minutes.
- Made of good quality, durable and strong support for long-time use.
- A good replacement for the broken lift support struts.
- This is a non-OEM product, accessory only!
Fitment:
- for Fiat 500 modello 312 332 2007-present
Note:
- If the temperature is lower than minus 20 degrees, the oil density of gas spring turn high (frozen), and it is difficult to press down.
Package Included:
- 2 Pcs Lift Supports Struts
Installation
- STEP 1: Please use safety stands under the vehicle or supports when you install gas struts. It is more easier and convenient if someone could help you open the hood or tailgate.
- STEP 2: Before removing the old gas struts, check the end connection and compare the extended length of your car Old one to make sure they are same.
- STEP 3: Put a small flat headed screw driver on the end of U shaped band of gas struts and remove it. Turn the screw driver slowly and it will lift up on the band approx 1/8'', then pull the struts away from car.
- STEP 4: To install the new strut, please follow the same way in reverse. If the U band is not lifted up before installing the new support, it may be damaged.
- STEP 5: If the ends are not aligned, you may need to rotate the struts. First connect the shaft end of the bracket to the vehicle, and then rotate the entire body of the bracket clockwise to align the ends.
Specification:
- Material: Carbon Steel
- Color: Black
- Placement on Vehicle: Rear Hatch
- Extended Length: 45.5cm/ 17.91"
- Compressed Length: 28.5cm/ 11.22"
- Housing Diameter: 18mm/ 0.71"
- Connecting Rod Diameter: 8mm/ 0.31"
Recommended Products