Your cart is empty.
Your cart is empty.Michael
Reviewed in the United States on September 12, 2024
Best money for a break you can spend
Clyde
Reviewed in the United States on March 26, 2023
The parts provided for fabrication were ok. The laser cut parts were really dirty. They should have been run through a tumbler. The machine work on the top die holder and clamp bar was excellent and fit very well. My biggest complaint was following the weld instructions provided. The lower V die should be stitched welded, not full weld. There’s no need to have that much weld, just stitch it and forget it. You WILL NEED to press flat if you full weld this angle iron in place.
JRWII
Reviewed in the United States on October 3, 2022
There were no issues welding kit together. Functioning as stated
bob
Reviewed in the United States on April 10, 2020
Game changer for my home shop
canoer79
Reviewed in the United States on December 4, 2015
Excellent product. This is the weld it yourself package. If you have the skills it's not difficult and saves some money. As for the quality of the product. I've easily done 90 degree breaks on 3/16" steel. Haven't had the need for doing anything thicker, but it handled that with ease. So I have no doubts as to the capabilities of this unit. I did pair it with a Torin 20 ton air/hydraulic jack which makes for an excellent setup. When welding the threaded rod sections into the steel tubes used for the stop I found that if you set them up into their position with the nuts and clamp everything down to your welding table with the stop supports square and true to the lower die section you will have a straight and true stop guide.
Recommended Products
$81.22
$ 40 .31 $40.31