Shopping Cart

Your cart is empty.

Your cart is empty.

Paddle Boat 2 3 5 Seater Rudder Kit, Exclusive Stainless Steel Material & Reduced Resistance Design, Compatible with Sundolphin & Sun Slider Pedal Boat, KL Industries, Sea Hawk

Free shipping on orders over $29.99

$39.27

$ 20 .15 $20.15

In Stock
  • ESSENTIAL COMPONENT: Our Pedalboat rudder kit is an indispensable element of the steering system, acting as the "fins" of a pedal boat. It allows for the control of the rudder's direction by manipulating the handle grip, thereby altering the vessel's movement in the water
  • STAINLESS STEEL COMPOSITION: We've redefined the construction of this product, initially adopting stainless steel for anti-rust and enhanced impact resistance. This material swiftly deflects water flow, aiding the vessel in rapid changes of direction
  • REDUCE FORWARD RESISTANCE: We have refined the cross-sectional profile of the stainless steel rudder, making it thinner to achieve a sharper cut through water flow. This modification significantly reduces resistance for the pedal-operated boat during forward movement, allowing occupants to experience the joy of effortless propulsion
  • SIMPLE INSTALLATION: Installation is easily accomplished by securing the stainless steel rudder with the direct use of an R-type pin and a cylindrical pin. It's important to note that the rudder board should be vertically installed when the boat is in the water. Conversely, when the boat is pulled ashore, horizontal installation is required
  • WIDE APPLICABILITY: Our kit is specifically designed for Sundolphin 3, 4, 5, and 5 Slider Pedal Boats/ KL Industries/ Sea Hawk, providing perfect assistance to the operation of various watercraft


HG-078


Mary T.
Reviewed in the United States on July 24, 2024
Nice project, very durable!
CEW
Reviewed in the United States on July 22, 2024
Two pre drilled holes with posts and clips make this a very easy install.
nick
Reviewed in the United States on July 21, 2024
The rudder itself is a nice metal piece. However good luck getting the pin through the hole in the clip. Does not fit. The hole is too small. I even tried some lubricant on it. No luck. Once you get the pin even partially in you can't get it out. Had to take a ring off my key chain and use that.