Your cart is empty.
Your cart is empty.LASCO 02-3307 white plastic toilet seat 3/4-Inch x 1-3/16-Inch oval push-in replacement bumpers. Toilet seat white plastic replacement bumpers, 3/4-Inch x 1-3/16-Inch oval push- in, 2 pieces.
Jasmine Lee
Reviewed in Canada on February 24, 2025
The item received is not the same as described. It does not fit snuggly and is much thicker than the one shown in the photo. Do not buy.
Steve C.
Reviewed in the United States on January 31, 2025
Perfect fit. Install couldn’t be easier.
Matthew K.
Reviewed in the United States on September 7, 2024
The item is not the one in the picture. Mine came with two thin posts on each, not like the ones in the picture that adjust to the hole size. The only way this will stay in the holes is to glue them in place. The size is correct, but the posts are not the same as pictured and too narrow.
excalibur
Reviewed in Canada on July 19, 2024
does the job
Bee Jay Em
Reviewed in Canada on March 15, 2024
I had to widen the holes to fit them into the existing holes. I broke one of the pegs in the process and the other wouldn't stay either, so I had to PL (glue) them to the underside of the toilet seat. Not worth it, in my opinion.
Ken Power
Reviewed in Canada on February 27, 2024
liked
Sue
Reviewed in Canada on June 14, 2023
These were a little hard to get in but I made them work by chipping of a part of the plastic. Seems to work fine
Sean Daugherty
Reviewed in the United States on December 11, 2023
I bought these as a replacement for the old, crumbling bumpers on my wooden toilet seat.While it is true that the pegs on these aren't tapered like those shown in the picture, I had no trouble pushing them in by hand, and they are nice and snug.The bumpers are slightly thicker than the old ones, but not enough to be a problem.My only gripe is that they are white and look a bit out of place on my brown seat. Having this available in brown would have been nice.
Peter
Reviewed in Canada on June 29, 2022
everything worked perfectly
Lemontwistersister
Reviewed in the United States on May 7, 2021
Thought would fit toilet seat intended but posts were slightly thicker and i needed to whittle down with an exacto knife. Wasn't hard just do slow from top down into underside. Took small slices off and it fit snug into holes 👍Mom's building wanted to charge her $25 for new seat 🙄.. because if live in a senior building and you " break " anything or have a bulb blow out resident has a list to see what's replacement costs out of their pocket. I get it if resident is destructive but if can replace cheaper ( bulbs/ handles/ toilet bumpers ) worth it . Hope this helps.Oh if can use a centimeter ruler( look for cm on 1 side of ruler if have ) it helps to get diameter of hole . I was of by 3 cm hence shaving a bit off. For $5 worth it than $25 new seat.
Emma Swinemar
Reviewed in Canada on November 27, 2020
The pads fit in existing holes so installation was easy. Too early yet for proper review. Will have to see how well they last.
charlie
Reviewed in Canada on October 17, 2020
Used to replace two front bumpers on an old toilet seat. Fit just as original.
Bill B
Reviewed in the United States on November 18, 2019
Be very careful. When you push them in, the posts aren't very firm, so if the holes in your toilet seat aren't quite wide enough, the posts will bend or break.If they don't go in with some light taps of a hammer, take a knife or file and open the holes up a bit more.
Recommended Products
