Your cart is empty.
Your cart is empty.Product Description
Bathroom Faucet black
Easy Installation
Step 1
Remove the rubber washer，metal washer and locking nut from the faucet.
Step 2
Screw and hand tighten the hot and cold flexible hoses to the faucet.
DO NOT use a wrench to tighten hose as this may damage the hose and /or the hose threads.
Step 3
Install faucet through center hole.
Step 4
Re-install the rubber washer followed by the metal washer and lock-nut.
Hand tighten,then tighten further using a screw driver to tighten lock-nut screws.
Richard
Reviewed in Canada on April 1, 2025
Really good value for the price. Just be mindful that if you are replacing an older tap with a drain lift assembly this does not have that. Had to buy one of those push button stoppers to complete the job.
Emmanuel Gagné
Reviewed in Canada on September 29, 2024
The media could not be loaded.
MCM
Reviewed in the United States on September 18, 2024
The faucet was easy to install. It looks good, functions well, smooth handle movement, great water flow, and is a solid fixture. Also great value for the money.
Swiggy Swooty
Reviewed in the United States on September 13, 2024
Works fine
James T.
Reviewed in Canada on June 28, 2024
They look good but take a bit of work to stop them from leaking. Couple trips to the hardware store and a couple extra washers and seem to be fine.
Goodguy
Reviewed in the United States on October 5, 2023
Looks great for the value.
Aman
Reviewed in Canada on June 24, 2022
Not a reliable product, start leaking in few months, leakages damaged my ceiling. Leaked happen where the tab joints the pipe. Better shop at lowes or home depot
Donald M.
Reviewed in Canada on January 20, 2021
This is the most noises tap set I have ever heard not sure why but would not buy this item again
Emil Pop
Reviewed in the United Kingdom on April 9, 2018
Works as it should
C. Winton
Reviewed in the United States on January 25, 2016
This is a really good piece of equipment, surprisingly heavy duty and well configured for its price point. I have a small Corian bar sink configured for a single hole fixture. The typical bar fixture reaches too high for my setup since there is a cabinet overhead. For that reason I needed a lower profile fixture. Not being familiar with this brand, but finding nothing comparable except for some rather expensive German versions, I decided to take a chance on this one. In truth, I couldn't be more pleased with looks, form, and function. The water stream comes out at a nice angle into the sink and the lever control is very smooth, allowing easy regulation of water volume. No drips either and a very even flow from the aerator. Installation is straight forward using the supplied wire wrapped hoses. A large brass heavy gauge threaded tube is supplied to attached the fixture to the deck using a heavy duty brass knurl. Washers are supplied to cushion the deck from fixture and knurl. Construction is excellent, especially for the price point. One word of warning. The supplied hoses are 12" and use an uncommon double O-ring seal system for attaching to the fixture (the supply line end is for standard compression connections). So if you need a longer than 12" hose you will have to fabricate an extension for the supplied hoses, a minor exercise plumbers routinely encounter. Since I just installed the fixture I don't yet know how durable it will prove to be, but from all appearances it is high quality construction that I expect will last as long as the best stuff out there. If I'm wrong about that I will revisit this review accordingly.
Recommended Products