Shopping Cart

Your cart is empty.

Your cart is empty.

BEP 716-SQ-140A-DVSR Square Battery Distribution Cluster for Single Engine with Two Battery Banks

Free shipping on orders over $29.99

$233.09

$ 71 .28 $71.28

In Stock
  • Package length: 7.2 cm
  • Package width: 15.2 cm
  • Package height: 19.8 cm
  • Product Type: ELECTRONIC SWITCH


The 716-SQ-140A-DVSR is an ideal replacement for a battery selector switch. Just remove the selector switch and connect the existing wires to a 716 cluster, no extra wires are required for a fully automatic battery management system. To be used in single Outboard dual battery bank or single alternator Inboard engine dual battery bank.


Angela Barrios
Reviewed in the United States on November 18, 2024
The switches are very robust and have an anti-corrosion coding on them. Also the DVSR is really cool and will allow your starting and house batteries to charge at the same time. I would highly recommend using this on any application. It’s also customizable and you don’t have to use it in the square configuration that is shown on the picture.
Paul The Peddler
Reviewed in the United States on July 19, 2021
15 minute install tested and working perfectly, not worried about a dead start battery at the sandbar with the radio on for a few hours, also less strain on the stator recharging the house battery, before even with battery 1 off on the Perko it still didn’t fully isolate them the way they are now, well worth it to me
Chipmonkey
Reviewed in the United States on March 31, 2021
Excellent product!! A must have if you’re running a starter and house battery on your boat!!
Austin Kneeskern
Reviewed in the United States on March 18, 2021
Great product, works flawless as battery cut offs for both house and cranking battery and never have to worry about either going dead on long days on the water
Michael Sem
Reviewed in the United States on September 9, 2020
I hear they work well to isolate the batteries.The design looks good until you start to install it.I loosened the terminal nuts so I could install the wires. The cluster became so o loose it started to separate into four sections. I taped around the outside yo help hold it together until I connected all the wires. How do they make this and not realize this problem?Once all leads were connected I th ighted it up and mounted it . Could have been so much better if they would stay together .
Recommended Products

$6.40

$ 2 .87 $2.87

4.6
Select Option

$44.73

$ 22 .31 $22.31

4.6
Select Option