Your cart is empty.
Your cart is empty.Daryl Bolen
Reviewed in Canada on May 22, 2025
works well and very bright
Julia
Reviewed in Canada on April 14, 2025
I have a Mazda 3 2015.Lights were getting a bit outdated and it was actually a bit hard seeing at night especially on the highway where I could barely see the lines on the ground especially in harsh weather conditions.Took about 40mins to install which should've been 20mins (5mins each light bulb) but it was my first time with almost 0 car mechanic experience. It’s truly a plug and play light bulb. Look up a few YouTube videos and got it done.Lights looks very bright and modern, it's like I'm driving on my new 2025 Mazda 3.Only problem is, this is specific for this make and vehicle and light bulb is that, your running Lights (when there's sun outside) won't turn on and I have to turn my normal lights manually, which kinda looks a bit off because you'll drive around and see most vehicles on the road with normal running lights but then there's you and everyone else like you who bought LED for their cars with their lights on lol. Not really a big deal, I actually didn't notice it until I was driving around the evening and noticed my lights weren't on and then later they came out cos it got dark enough and then I looked online and it’s a normal problem to have.Quality, brightness, build, all 5/5. Trusted brand.
Trevor Kemble
Reviewed in Canada on September 22, 2024
purchased this product as a package deal for my wife’s vehicle, the led high beams work perfect so far no issues, the low beams (H11) on the otherhand are absolute crap, i installed them following directions etc, it took approx 30 seconds and they both overheated and shut off, the back of the bulbs was so hot i burnt my fingers, i doubled checked the connections, and reinstalled them (actually switched them) thinking maybe they were meant to go in different sides, only to have them both overheat again and shut off! so much for plug and play!load of crap!I had to go out and purchase a set of bulbs from C/T, and low and behold they work just fine! i would NOT recommend this product.* Side Note waiting for high beams to start overheating, or worst case burst into flames while i’m driving!its to bad, i have purchased other bulds for my truck and never had any issues!
Lucas
Reviewed in Canada on September 13, 2024
Bought for a 2024 Suzuki kingquad 750 and these lights are nice and bright and was super easy to install, definitely would buy again if I need them.
Rudiger
Reviewed in Canada on March 18, 2024
These lights are probably the best H4 retrofit you'll find for the price. Light cutoff was great, fit perfectly in the housing, and good light output. The white light colour also helps modernise older vehicles. If they work fine on your vehicle, then you can't go wrong, especially when they're on sale.However, I had an issue with them in my vehicle. Not sure what caused it, but with these installed, my auto power windows would not work. For fear of causing electrical problems down the road, I removed them, and will be returning them. I did not try the Canbus Decoders, as that's an additional cost that isn't guaranteed to work.I will add as well, I didn't find these to be shockingly bright, like some reviews suggest. Light output was comparable to a high quality halogen. If you are coming from an old, worn out, cheap bulb, I can see the difference being great. But don't expect anything crazy. Light output is very comparable to a Sylvania Silverstar bulb.
Dave
Reviewed in Canada on February 13, 2024
Imparting two identical Yamaha Phaser Four Stroke snowmobiles, one with standard Halogen headlights (2 per sled) and the other with these Auxito LED is like night vs day. The LEDs really are as advertised - they claim five times brighter. They are worth the price. The reason they were purchased was to address a hard to cold start the snowmobile.I replaced two 60 Watt Halogen bulbs with these two 13 watt Auxito LED bulbs. The intent was to reduce the demand on the battery on a 2007 Yamaha Phaser Snowmobile that did not get the ECM recall to remedy hard cold starting. The recall is over now and an updated ECM is $1000. By reducing the wattage of headlights by 94 watts, this would allow about 8 more amps to the starter motor to crank the engine over more quickly -thus increasing oil pressure and allowing fuel flow to the engine. These Led lights along with a Noco Lipo powersports battery have made the sled much easier to start. Mission accomplished and wicked night light on the old 2007 sled.
Darren Matilpi
Reviewed in Canada on October 1, 2024
These light up the night! The evening prior to my install a black bear crossed in front of me and I barely saw it. Put the Auxito lights in right away next morning. Now everything is lit up in front. I love these lights and their output. Fans are a little loud but not a deal breaker. Sometimes they flicker but not a whole lot. Don't need a decoder. Good to great lightoutput.Update so these light began flickering regularly. Went to purchase antiflicker harness to discover the diodes on passenger side had stopped working , and they are not worth purchasing. Spend the extra money and buy higher quality LEDs..less than a year..and these light faded to black..not worth buying
pumpkin
Reviewed in Canada on February 2, 2023
I bought the HB/HB2/9004 version for my 2011 Honda CRV. It exceeded my expectations as the product description states that the DRL function would not work, but it does on my car. Specifically, I get true hi-beam, lo-beam and DRL functionality (DRL on my car is the hi-beams operating at lower intensity). The light output is very bright, and cool-white (manufacturer claims 6500K…probably true), and superior to the OEM incandescents. There has been no flickering, but admittedly I've only had the lights for 6 weeks.Installation was a little tough on the driver’s side of the CRV as there is not much wiggle space in front of the battery, but that is honda’s fault, and not the related to the bulb. It was also hard to fit the OEM rubber gasket over the back end of this bulb…it was a very tight fit, I suspect the base is maybe a millimeter bigger in diameter than the OEM. I did not take off a star for this as I am very happy overall and the tight fit will likely be a net benefit in terms of keeping dust and moisture out of the headlight cavity.(P.S. DRL is mandatory by law in Canada)
Recommended Products